Belysning/Dekorativ/LED Stripes

SmartLife LED-Stripe

Wi-Fi | Kald Hvit / RGB / Varm Hvit | SMD | 5.00 m | IP44 | 2700 - 6500 K | 960 lm | Android™ / IOS

Egenskaper

Leverandør Delenummer: WIFILS50CRGBW
Strek nummer: 5412810303106
• Enkel å sette opp - koble den til Wi-Fi-nettverket for å stille inn, kontrollere og tidsplanlegge LED-listen
• Rød, grønn og blå farge er tilgjengelig, eller så kan du kan velge nyanser av hvitt fra varmt til kaldt - alt etter humøret ditt
• Listen kan gjøres kortere eller lengre - for uendelige muligheter
• Dobbeltsidig klebeevne (3M) allerede påført - for enkel montering
• Fungerer som frittstående smartbelysning - kan også kombineres med andre SmartLife-produkter for å skape et komplett smarthjem
Skap stemning i alle rom med denne smarte LED-listen. Kontroller den i applikasjonen Nedis SmartLife, angi tidsplaner og automatiske oppgaver, eller bruk dine favoritt-talestyringer til å kontrollere lysstyrken og fargen på LED-listen. Den kan kobles direkte til Wi-Fi-nettverket, slik at du ikke trenger noe separat tilkoblingspunkt.
Siden denne LED-listen kombinerer både RGB- og varme og kjølige hvite LED-lamper, kan du lyse opp med den fargen du vil, eller bruke listen til å skape varmt eller kjølig, hvitt, indirekte lys
Lengden på 5 meter kan gjøres kortere eller lengre med lignende LED-lister, så mulighetene er uendelige
Det dobbeltsidige limet (3M) er allerede påført for enkel montering på enhver ren og flat overflate.

Emballasje

Innholdet i pakken

RGBW LED-list (5 m)
Wi-Fi-fjernkontroll
Strømforsyning
Hurtigveiledning

Forpaknings størrelse Gaveeske med eurolock

Bredde Høyde Lengde
50 mm 190 mm 185 mm

Logistikk størrelse

Antall/kartong Bredde Høyde Lengde Vekt
1 182 mm 50 mm 210 mm 420 g
8 195 mm 245 mm 420 mm 3720 g
32 410 mm 440 mm 510 mm 16000 g

Produktspesifikasjoner

Bredde 151 mm
Høyde 8 mm
Dybde 5000 mm
Vekt 310 g
Inngangsspenning 220 - 240 V AC 50/60 Hz
Maksimal antenneforsterkning for overføring 2.5 dBi
Kompatibel med Nedis® SmartLife
Strømkabel adapter lengde 1.50 m
Maksimal overføringseffekt 16 dBm
Fargegjengivelsesindeks (Ra) 80
Lysfarge Varm Hvit
Kald Hvit
RGB
App tilgjengelig for Android™
IOS
Kapsling IP44
Maksimum forbruk strøm 15 W
Nettplugg Euro (CEE 7/16)
Dimbar Ja
Nominell lampelevetid 20000 h
Støttet trådløs teknologi Wi-Fi
Skjærbar Ja
Energiforbruk per 1000 timer 15 kWh
Materiale Silikon
Feste Overflatemontert
Uttrekkbar lyslist Ja
Send frekvensområdet 2412 - 2484 MHz
Antall produkter i pakken 1 stk.
Enhetens inngangsforbindelse ® DC
Fargetemperatur 2700 - 6500 K
Energiklasse F
Nominell lysfluks 960 lm
Farge Flerfarget
Kabel lengde 5.00 m
LED Type SMD
LED-modul SMD 5050
Antall leds per meter 90 stk.

Støtte

Vanlige spørsmål

Vi har funnet følgende spørsmål til deg på engelsk

No, the LED's are not individually addressable.

Please try the AP mode.

Make sure that you use a 2.4Ghz wifi network.

Reset the controller so the LED strip blinks slow. (press and hold the button on the controller)

If it blinks fast, reset it again and it will blink slowly



In the app:

+ > [your device] > tap on EZ mode and select AP mode > confirm it was reset > fill in the info of your wifi network > follow the steps in the app.



Hold your phone very close to the plug during the installation

This method uses a direct connection to the device to send the info of your wifi to it.

Holding it close optimises this connection

Ensure that you only take off the plastic protection and not the entire adhesive strip.
If you remove the whole strip, you will not be able to stick it to anything.

Yes, you can purchase another set and plug the second strip in the first one.
If you extend it to 10m (5m extra) then you might see some loss in brightness at the end of the second strip.
We recommend you install multiple complete sets and group them in the app.
Now you can control all of the strips as if they are a single strip without any loss in brightness.

Yes you can.
Each person needs a unique account on their mobile device.
To add them as "family members" follow these steps:
In the main screen of the app tap on the name of your home (top left)
Tap on Home management
Tap on the name of your home again.
Tap on "add family members" and fill in the account details of the person you want to add.
It will give them access to all the devices in your home as a normal member or admin (you can select this)

If you only want to share a single device in a home, go to the settings menu of the device and select "share device" -> add member.

This is probably a Wifi problem, this can be for various reasons.
1.) Wifi signal is unstable.
2.) Wifi signal is too weak.
3.) Using an access point with the same SSID and password that do not support the IEEE 802.11R standards.

Problem 1 can often be solved by restarting the router.
Problem 2 can be checked with an app Wifi analyzer with this the signal can be viewed and corrected to a better position.
Problem 3 can be checked as the access points are turned off, the Wifi signal is still good and the connection remains if the access points are a problem, a Mesh solution can then be used.
Please make sure that they support IEEE 802.11R standard.